-
NJSPC version: 7.1.0 Master Branch
Following docs here:
https://github.com/tagyoureit/nodejs-poolController/wiki/Bindings-Integrations-in-2.0#set-values-with-mqtt
Publishing this to MQTT broke…
-
Changing IntelliFlow pump RPM results in outbound message error.
Changing the pump speed results in:
Message aborted after 3 attempt(s): 165,1,16,33,155,47,1,128,0,0,0,6,10,1,11,0,0,0,0,0,0,0,0,…
-
Working on mcsMQTT homseer integration of poolController.
When mcsMQTT broker is taken offline, and then later enabled, mcsMQTT receives about a thousand messages for each minute that mcsMQTT was o…
-
Lost connection to RS485
Getting no comms to the equipment I have, used to work tried changing the RS485 adapter to no avail
```
> nodejs-poolcontroller@6.5.1 start
> npm run build && no…
-
**Expected behavior**
A clear and concise description of what you expected to happen.
**All I really need is pump control for now. A few commands.**
**Using Pi3b, 64 gb card, JBtek USB to RS48…
-
How do I use the nixie controller, how to get started?
@tagyoureit
-
Hi Brad, Two questions for you, sir:
1) I have a single Intelliflow VS pump and a Rpi running the pool controller and webclient. I've installed the HE driver and everything works fine, however when…
-
Easytouch2 8
Can start "Super Chlor" function just fine from dashPanel, but for the time period set for super chlor, I can not turn off pool. The pool is locked out by the super chlor function.
…
-
Easytouch2 8
Can start "Super Chlor" function just fine from dashPanel, but for the time period set for super chlor, I can not turn off pool. The pool is locked out by the super chlor function.
…
-
### The problem
I am a new Hayward OmniLogic user and wanted to setup this integration. When adding the integration, I see the card show up in the list of integrations but no sensors are detected. …