-
I ordered a small run of your Cing ultrasonic printed circuit boards from:
https://www.pcbway.com/project/shareproject/I2C_Ultrasonic_sensor_with_compensation.html
The silkscreen shows parts place…
-
It would be helpful to have photos of the front of each EEM in the Wiki (seen from outside the rack). The wiki seems to be the best place for speccing out a new Kasli system, but it's hard to get a go…
-
### Is your feature request related to a problem? Please describe.
New 2.2 boards support battery measurement.
### Describe the solution you'd like
Battery voltage is measured every couple of min…
-
### Board
esp32 dev kitv1
### Device Description
ESP32 Devkit V1
### Hardware Configuration
ex
### Version
latest master (checkout manually)
### IDE Name
Arduino IDE 1.18.9
…
-
I am getting acquainted with inav on the H743 circuit board from weact, and am having problems receiving gyro (BMI160). I tried with the servo on motor 1 with the default settings and the servo vibrat…
-
Hey, I am trying to play with both Dytech and Bobs together. The problem is that the assembly machine 1 requires a gearbox, the gearbox requires a basic electronic circuit, the basic circuit requires …
-
The MENB circuitry and logic is contained in the PSAT circuit and should be removed from the LMP91000 library. Ideally, the LMP91000 library is board/pin agnostic.
-
Lab notes about adding power measurement circuitry in the the latest [power supply](https://github.com/racklet/electronics-prototyping/tree/hat-psu/hat-psu/LMR14050SDDA_reference) board.
Some old n…
-
Page 3 page of PDF "mppt-2420-rc" (sheet "/Power Supply/") defines "HV +" and "LV +" as inputs to the sub-circuit; on page 1 (sheet "/"), these are linked to "DCDC_HV+" and "DCDC_LV+" resp..
The cir…
-
### The problem
Whether using the "servo.detach" instruction in the service section or "auto_detach_time" in the servo section or both, the servo does not detach.
The message" Servo detached on au…