-
Hey @gskjold
I have an issue where the data is not shown using my Danish Kamstrup Omnipower meter running on POW-K from @ArnieO. The HAN module is just red.
Here is a dump from the log
```
…
-
I am currently writing new code to interpret data from the meter. The new firmware should support any IEC62056-7-5 (Norwegian and Danish meters with HDLC payload) and IEC62056-21 (Swedish and possibly…
-
Have been struggling a bit with my brand new Sagemcom T211 (with the P1 interface activated). Don't know if it's the meter that is not supported or anything else (I'm not a programmer).
**lsusb** …
-
På marknaden verkar just nu de flesta tillverkare av smart hemutrustning använda rj45 för att ansluta till elmätaren. Men samtidigt har många mätare rj11 eller rj12. Skulle ni säga att det är möjligt …
-
For some situation it might be useful to offset a cycle - e.g. to avoid triggering loads of telegrams at the same time. Therefore the possibility to offset a cycle of items and logics would be nice.
…
-
errlog is show
```
[build] : && /opt/zlg/gcc-linaro-arm-linux-gnueabihf-4.9-2014.09_linux/bin/arm-linux-gnueabihf-g++ -std=c++11 -fPIC -pthread -g CMakeFiles/smartdc.dir/src/main/src/event.cpp.o…
Layty updated
3 years ago
-
Se não tiveres, inside info, diria que é impossível.
Pelo menos do lado da HAN.
Mudar o ID, por exemplo, funciona perfeitamente.
-
Currently I try to get the data from my MA309 with your recommended hardware but it seems like the output coming from the serial port is almost garbage - any hints for me?
Output:
````
?~e?6}b?T…
-
Dresden-Elektronik should consider adding native serial protocol (UART) support for ConBee and RaspBee hardware to open source home automation software such as Home Assistant and its Hass.io (Home As…
-
**Language information**
There is a Markdown parser for treesitter: https://github.com/ikatyang/tree-sitter-markdown
As I understand it, this was already in this repository, but has been removed…