-
Versions: 5.14.0, 6.2.1
Hardware: Electrodragon module
Description:
Blink mode with 500ms time (will test others times later) blinks only 5 - 7 times. After that, blinking stops and module reboot…
-
Hello
I'm using the Electrodragon IoT Relay to control all the shutters of my house (with FHEM and Tablet UI interface).
W…
MTrab updated
5 years ago
-
Tested with Electrodragon SPDT module.
Flasched ESPEasy: working.
Flasched Tasmota 5.12.0c: working.
Flashed Tasmota sonoff6.1.1c: Wifi only working for short times, mostly no ping answer.
Ping s…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
Ok, so I think I've wired both atmega2560 and ESP01 properly. What I can't figure out is what I'm supposed to do on the ESP part. Surely the module has to be uploaded with some code to be able to comm…
-
Hello,
sometimes the pytracker just stopped and didn't send anything anymore, so really only happened once. But if that happens in the air, we have a problem. Is it possible to set up a timeout? If…
-
Hi All,
ESP abecomes unavailable after sometime intermittently where it says
Connection to http://192.168.1.4:80 refused
org.apache.http.conn.HttpHostConnectException: Connection to http://192.168.1.…
-
Hi @arendst,
after upgrading to the release v5.12.0a, 2 days ago, I notice reachability problems on all my NodeMCU and Electrodragon board. In the log I notice continuous connection attempts to the…
-
Good day. A noob question. Will i be able to use other GPIO Pins if I use the adapter board provided?
My project needs to daisy chain 6 panels and at the same time a GSM module connected to the Ras…