-
Maybe add a feature that if _x_ amount of the same messages is published within _y_ amount of time, then just send one message saying that. Instead of publishing all the messages, then goto sleep on …
-
Setup : ImmersionRC Vortex 230 Mojo stock
Configurator: 10.5.1
Firmware: BTFL 4.0.0
Target: IRCSYNERGYF3
I have a problem with my Mojo, since I've upgrade to BF4
I had no problem with 3.2 versi…
ChDUP updated
5 years ago
-
I have a Banggood Omnibus F4 V3 (with Sd Card) setup using a UBLOX spec GPS. I have the I2C remapped from UART3, I have the GPS on UART1, and both the mag and gps work great. Since the R9 Slim only ha…
-
The use of the actuator allows obtaining a very realistic result for linear or rotary displacement systems but limited within a certain range of values. While it does not work properly for multi-turn …
-
It appears something in r128gain's opus handling has broken between release 0.7.1 and the latest. For example the command `r128gain -r -a -o .` previously ran without error on a directory of .opus f…
-
**Describe the bug**
If I set up the current sensor in Betaflight for the new Airbot F7, the current sensor shows a permant current and didn't change. If I plug in the Batterie, the current sensor sh…
-
**Describe the bug**
The FC reads the ESC very random. Sometimes not at all, other times, 2 or 3 escs in the stack.
**To Reproduce**
Updated to betaflight 4.0
**Expected behavior**
I expected…
-
I've been on the fence about reporting this one as the answer might be "quit trying to run r128gain on a Raspberry Pi". But since the behaviour varies by the content being analyzed I'll go ahead and …
-
matek f722se upon disarm voltage and current sensor values change
put an f722se on 4.0 and arm and disarm
THIS DOES NOT HAPPEN ON 3.5.7
video
https://www.youtube.com/watch?v=bFI3rs8zv4s&feat…
-
Hi,
There may be a bug with the Acro Trainer mode activation.
I have tried to configure it so that it activates with two switches by adding a second range so that it uses two auxiliary channel s…