-
If I want to be able to send the signal to my entire house, how do I build such a thing?
-
I'm working on a symbol for an optocoupler, and I'm a bit in doubt how to proceed wrt distinguishing between open-collector and push-pull images..
I'm working on the Si8735, which is drawn in the…
-
- [ ] Many lacking good description
- [ ] Many lacking footprint information
- [ ] A lot of KLC issues to fix
Move obsolete symbols:
- [x] Memory_Controller
- [x] Memory_EEPROM
- [x] Memory_EP…
-
The MDBT50Q-1MV2; how does one go about programming flashing? Is it simple SMD solder all the required components and then flash it with ZMK firmware? Or do I need to figure out how to flash it with n…
-
I am curious if this can be used on a TI-99/4A computer.
the PHROM data on the TI was split into 2 TMS6100 ICs that were piggy backed on the unit. I have the actual dump of the PHROMs but how woul…
-
Any reason https://recom-power.com/pdf/Innoline/R-78-1.0.pdf wouldn't be a suitable (superior) replacement for the MCP1826S-3302E-AB?
Looks like the specs are basically identical, but this is a swi…
-
Hello. I was wondering if it is possible to replace the hardware reset with the AT # CZ command. It would simplify things a bit. The second question. In the diagrams it is shown that the reset is conn…
-
Hi
Thank you for making this available. I've ordered 5 boards from JLCPCB and it came to $10.99 including shipping to Denmark. I'm a software guy and I've never attempted to build anything like this…
-
As mentioned in https://github.com/KiCad/kicad-symbols/pull/310#issuecomment-379883615, our nomenclature for USB Type-C symbols could use improvement. In particular, there are several types of connec…
-
For example:
`https://www.infineon.com/dgdl/irf7601pbf.pdf?fileId=5546d462533600a4015356038df01c74
`
This is because of three reasons:
- it calls the function .lower() and changes fileId to fileid…