-
MacOS Mojave latest version of DragonOrder + new Octoprint install.
Plugin installs normally, no issues. Tabs & sidebar items can be rearranged. Popup message about Shift + Reload/Refresh when fin…
-
Hello, I am unable to get TouchUI to connect, I believe there may have been conflicting directory or driver inputs during the install but I am not familiar enough with this system to track it down I w…
-
### Description
SKR Mini E3 1.2 board. If I print from the SD card, with Octoprint or Pronterface in Connected state (not just plugged-in), prints do not finish correctly.
When finished, th…
-
Please provide *general* feedback on your experience with the 1.3.12rc1 Release Candidate here. An "All is working fine" is valuable feedback as well, because it tells me that people in fact are testi…
-
Whenever I install a new plugin(**after** installing RGB status) i have to reboot the entire Raspberry Pi because Octoprint can't bind to the port 5000, because it says it's still in use:
`2020-05-02…
vldfr updated
4 years ago
-
I have a fresh install of v138. The first plugin I installed was touchui, then I installed the pi desktop environment via cmd line and it does not seem to launch either via web access or the desktop. …
-
I am running Octoprint 1.4.0 on OctoPi 0.16.0 on a Raspberry Pi 3B.
I noticed that RPi data are shown **before** print starts, but get frozen **after** printing starts (see picture 1).
When open…
-
This is awesome! However... for me in both Chrome/Firefox I find that the tabs all get pushed below the Connection/State/Files elements at the left of the screen, rather than going alongside them.
…
-
My chromium browser only worked for a split second after the initial installation. Now the browser will not open at all. The icon is there and when I click on it I get a loading cursor.
X.Org X Ser…
-
Hello, sorry to be back with another issue but this one is driving me mad.
Firstly, I was unable to restore my backup due to an I/O error ([Errno 16] Device or resource busy) which I just gave up o…