-
I keep getting "Not enough data received" error when I execute a forced recalibration. I believe it's because the wrong number of bytes is expected in a the response. The library expects 5 but the r…
-
Both sensors are connected through the i2c connection. TTGO TDisplay. Firmware rev851
The device only detects the SCD30 sensor.
The SCD30 sensor is disconnected (unplugged) and after a reset the…
-
Hi,
I just finished your instructions. I have an ESP8266 board, a Seeed SCD30 and a 3V piezo speaker. I had to download and integrate almost all of the libraries as zips because they were not found…
-
Hi,
I am going to create a new device in Iot.Device.Bindings and make a pull request.
However, I am worried about conflict with other developers.
Is there a mechanism for communicating in advance?
-
- Arduino board: **INSERT ARDUINO BOARD NAME/TYPE HERE**
- Adafruit ESP32 Huzzah
- Adafruit SCD30
- **INSERT ARDUINOVERSION HERE**
- 1.8.13
- List the steps to reproduce the problem below (i…
-
My setup is:
TTGO T-Display
Sensirion SPS30
Sensirion SCD30
On the graf i the app only CO2 shows value PM,Temp and Humidity shows zero
-
Hi @smuellerDD, Please forgive maybe the mistake of opening an issue here.
I am stuck on GRUB boot after I enable LRNG on OpenWrt x86_64 Linux 6.1.47.
LRNG Version: v50
Patch Files: https://git…
-
Hi, I'm kinda new here (no git and to ESP-IDF framework).
I was trying to figure out how littleFS works in the esp32 via the IDF framework, but I ran into multiple errors while trying to build the …
-
The [Sensirion SCD30](https://www.sensirion.com/en/environmental-sensors/carbon-dioxide-sensors/carbon-dioxide-sensors-scd30/) is a sensor module for HVAC and indoor air quality applications. There is…
-
Many thanks for the script - works out of the box! I have ordered a book on MicroPython from Elector to gain more insight into Micropython. While I have been able to trigger a relay using the built-in…