-
I have a Multiplus2 without an external Grid meter, and no easy possibility to install and connect one. I have a pseudo-smart meter provided by a Tibber pulse, and hope to use this as the grid meter. …
-
### Version
0.8.0 (current)
### VenusOS version
3.32
### Does this issue occur during installation or at runtime ?
Installation
### Is there a Discussion thread for this issue? Please paste a li…
-
### Describe the problem
Driver never connects to battery but does see the appropriate battery.
### Driver version
v1.3.20240705
### Venus OS device type
Raspberry Pi
### Venus OS version
v3.4…
-
### Describe the bug
Battery gets disconnected in the OS. It was working fine for months.
As you can see in the logs: the soc value is None and the software terminates.
### How to rep…
a1ad updated
2 months ago
-
### Describe the bug
**My Setup**
Victron Cerbo GX
Victron MPPT 250|100 Solar Charge Controller
Victron Multiplus-II 48/5000/70
Battery 1 - 280AH x18s LiFePo4, Daly 150A BMS, Parralel protection…
-
Dear All,
I have made a new release of the dbus-mqtt-driver that completely removes the YAML dependency from this project. This should address the problems that have plagued this project for month…
-
i have installed latest version
Thank you for your addition to the community
i have not installed anything except guimodes and setup helper
raspberry pi 3 keeps flashing up its temp then dis…
-
I changed the config.ini and I think I have a connection but the there ist an error in the following, I have a sun-2000-G3 but I think it is equal to the 1600. The problem can be that I have Firmware …
-
### Describe the problem
Dbus-serialbattery seems to start correctly, appears in remote console, communication to Jkbms occurs, but appears skipped because no device instance.
 in services.yml for grid are commented?
I have a very small installation (HM-600 / A…