-
When using single antenna mode `-A 1`, LTESniffer seems to ignore `-a id=2` selection. E.g. with any SDR this happens:
`sudo ./build/src/LTESniffer -A 1 -W 4 -f 1869900e3 -C -m 0 -a "num_recv_frame…
-
Using gqrx-2.15.8 and pulseaudio on Arch Linux
Gqrx crashes and dumps core on starting DSP processing when the audio output device it was using the previous time is no longer available. It should h…
-
hello
I'm using bladeRF-cli and i'm trying to set the bladeRF sample rate to 61.44M in both RX channels.
I'm executing the following script
`set frequency rx1 2.45G
set frequency rx2 2.45G
…
-
It was suggested here https://nuand.com/forums/viewtopic.php?f=5&t=3792&sid=9ec2f9cc209b95243d1a1e92c5bbed22 that the FPGA firmware maintains unsigned 64-bit counters
(see: rx_overflow_count and rt_o…
-
I made a small change in usrp.c to include looking for a match of X300. While this does in fact allow ice9 to find and appear to use the X310, there's zero information going into the pcap file which i…
-
wugong@wugong-ThinkPad-X200:~/LTE-Cell-Scanner/build$ cmake ../ -DUSE_HACKRF=1
-- Try to find OPENCL LIB
-- OpenCL LIB not found
-- Boost version: 1.54.0
-- Found the following Boost libraries:
-- …
-
i have a HackRF one and when i try to run grgsm_livemon
i get this
grgsm_livemon -f 943.0m
[INFO] [UHD] linux; GNU C++ version 10.2.1 20201207; Boost_107400; UHD_3.15.0.0-4+b1
[ERROR] SoapyS…
-
## Issue Description ##
I am trying to establish end-to-end 4G network and I have encountered an issue with SFN synchronization running the UE. After the message that SFN is not yet synchronized I …
-
Dear community,
is there a way to let GNSS-SDR output NMEA messages or other protocol on UART or SPI ?
In particular, I want a bladeRF x40 running GNSS-SDR 0.0.12 to output GGA, VTG, and RMC NMEA …
-
### What type of issue is this?
permanent - occurring repeatedly
### What issue are you facing?
Facing the following error using gqrx and gnuradio companion with a CCC rad1o SDR (rev5 hackrf firmwa…