-
### Description
Since version V3.025.1 of TFT35 V3.0, I notice a big degradation of the print quality.
So I ran some test print with a few software version as well as a print in Marlin Mode.
I n…
-
what is the difference between the versions: RC, RC_maple, RE?
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
1. I run a bed level using BLTouch and store setting.
2. do a test print and use babysteppin…
-
### Description
After setting up my new filament sensor (BTT SFS V1.0 Smart Filament Sensor) I was able to get it to work pretty good **in marlin mode** with the following changes:
Plugged senso…
-
I do not know any other way to contact, but I wanted to help out. The F1 vs F4 issue doesn't really have to be an issue. All you need to do is place the F1 bin in the root of the SD and the F4 bin in …
-
Hello,
I was really hoping with how popular the Ender 5 Plus has become that there would both similiar options like within the Ender 3 Pro folder of other boards. Specifically btt skr 1.4 Turbo w/ …
-
**Hardware Setup**
Ender 3 / Creatlity 4.2.2
**Describe the problem**
I tried [this guide](https://github.com/OctoPrint/OctoPrint-FirmwareUpdater/blob/master/doc/stm32flash.md) to flash the firmw…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
When using a MKS_ROBIN2 BOARD , latest Marlin 2.1.x dose not compile ...
PS E:\3D\Arduino…
-
Attempted to install " G32_maple-Pro UI-newtest.bin" on my Aquila C2 today. Have tried (on properly formatted SD) the bin file under the root and also under a folder "firmware".
When I power up I g…
-
IMPORTANT:
-First revision (6th March) > I reboot the printer (Control > Reboot), and now it turn on properly.
-Second revision (7th March) > After all night without power, the problem appeared…