-
### Duet Forum Discussion Thread
https://forum.duet3d.com/topic/27807/duet3-1lc-accelerometer-doesn-t-work-in-3-4-m956
### Which Duet products are you using?
- [ ] Duet2-Wifi
- [ ] Duet2-Eth…
-
DWC will display the filament error message even after acknowledging the event via PanelDue and the printer resuming printing.
UPDATE: the message continues to appear even after the print ended
Ho…
-
Hello,
i just installed klipper on my pi and wanted to flash my DUET Wifi.
After running make and creating the confi file, i was running
sudo make flash FLASH_DEVICE=/dev/serial/by-id/usb-Duet3D_Du…
-
This is now a feature in Klipper (https://www.klipper3d.org/Resonance_Compensation.html) that appears to get better results than [DAA](https://duet3d.dozuki.com/Wiki/Gcode#Section_M593_Configure_Dynam…
-
Maybe I'm just missing something but I'm wondering if it's possible to have run custom handling at the end of the print?
Specifically what I'm trying to do is switch from taking an image every layer …
-
Hello,
I'm trying to get my Duet 2 Wifi hooked up to Klipper. I am able to do the flash using Bossa on Windows but when I hook the Duet to the Raspberry Pi, it will not connect.
Enclosed is the l…
-
### Description
## Description
If the button "home all"is pressed the code generates (old) gcode and thus throws errors
"Warning: Obsolete use of S parameter on G1 command. Use H parameter instead.…
-
Hello,
i read you can control PSU with M80 M81 Commands with the following configuration.
[output_pin power]
pin: !ar12
value: 0
shutdown_value: 0
How do i know the pin number of my duet w…
-
Ok not really sure if it's spose to be an issue or a request? Anyways, here goes.
From what I understand the Duet 2 line is supported by klipper as of now.
I haven't really been able to dig up t…
-
Since Klipper already supports the TMC21xx family via SPI, I was wondering if there were any plans to support the TMC2660 drivers as well, since they are featured on the Duet 2 Wifi.