-
As python2 is no longer supported, it would be nice to have a python3 port. I had a look at it, but this seems to be too much for me. Could you please consider a port to python3?
kind regards, Lou…
-
Recently gnuradio was updated to release 3.8.
Using @velichkov tips in [https://github.com/ptrkrysik/gr-gsm/issues/480] I think I fixed the troubles with gnuradio and gr-grsm packages compatibility, …
-
When the flowgraph reconfiguration occurs (demodulator change, AM DC cancel change, global DC remove change, etc.), the audio recorder stops in background, leaving GUI button in pressed state.
Cond…
-
Hello!
I try to install MMDVMHost into Synology Virtual Machine.
First I install Debian 12 (clean install).
Then I make MMDVMHost
I get the same error every time I try to start MMDVMHost: **una…
-
Hello
I am trying to implement lower SF, and it looks like the transmitter can generate the signal, but the decoder fails to decode the signal. Do you have any suggestions about where to begin to ch…
-
### Feature Description
The manual page of 'QT GUI Number Sink' says that
'... due to a flaw in the implementation, this block cannot receive integer value inputs. It will take chars, shorts, and f…
-
Hi there,
I know it sounds stupid but there is no installation instructions. What are the right steps?
Needed for GNU Radio.... still struggling to build it from scratch and also with pybombs so …
-
Hi, I am trying to install the isdbt's blocks for gnu radio 3.10 (I tried to install 3.8 but no success) and when I run the cmake ../ command I get the following error, I tried many methods but nothin…
-
Hi,
I'm still learning to use BladeRF xA9 with GNU Radio Companion and wanted to modulate a signal and send it through a RF Cable and receive it on the receiver side and demodulate to retrieve the or…
-
Hur mycket jag än älskar att ratta oscilloskop, vilket uppmanas på några ställen i boken, så finns det idag alternativ med lägre instegströskel när det gäller att experimentera med modulationer o.d. J…