-
Hello i'm not able to get the micronucleus bootloader on attiny45, i'm pretty much a beginner, i tried to flash attiny85 build directly which may seem stupid, and it said the address of the beginning…
-
When using DigiSpark Board from Broad Manager "Hourly Build 2015/10/30 03:43" fails to compile provided examples. However, "Hourly Build 2015/08/28 11:09" does compile successfully.
This smells like…
-
_From @mpflaga on October 30, 2015 22:39_
When using DigiSpark Board from Broad Manager "Hourly Build 2015/10/30 03:43" fails to compile provided examples. However, "Hourly Build 2015/08/28 11:09" do…
-
It takes several seconds for the software to read from a T100 after it is plugged in. I believe this is due to the micronucleus bootloader. It would probably be good to minimize this time.
-
I cannot get a Digispark to flash using 'make program'
Charless-MacBook-Air:t100-firmware charles$ make program
avrdude -c usbasp -p attiny85 -U flash:w:main.hex:i
avrdude: error: could not find US…
-
We will have to add test points to the board for programming and testing.
-
I've been having some rather strange issues with flashing. I'd like to review the ATtiny85 fuse settings and confirm that they are as they should be. I'll be adding nots here as I learn more about fus…
-
The T100 has been assigned the Pax Instruments VID 0x2b51and T100 PID 0x1002 (https://github.com/PaxInstruments/t100-electronics/issues/22#issuecomment-75647746).
The micronucleus bootloader carries …
-
Hi,
I wanted to speed-up the boot time and I played with the AUTO_EXIT_MS delay, so that the Digispark waits less before starting the program.
At 1000ms it was ok. I tried 250ms and now it is not resp…
-
> Please plug in the device ...
> Press CTRL+C to terminate the program.
> Device is found!
> connecting: 16% complete
> connecting: 19% complete
> connecting: 22% complete
> connecting: 25% complete
…
hachi updated
9 years ago