-
Hi,
is it possible to provide a TFT32 version of the CNC firmware supporting grbl? I‘d really love to use the display with my cnc router 😊.
-
### Enhancement Summary
Switch to tasmota (TFT File)
### Detailed Description
I was wondering if I switch to tasmota if the custom TFT file could cause problems.
Is there a standard TFT file tha…
-
### TFT Version
4.3.9
### ESPHome Version
4.3.9
### Blueprint Version
4.3.7
### Panel Model
US
### What is the bug?
display settings page not showing. Page to control display brightness and o…
-
I have an s1 with factory installed sprite and was wanting to set max temp to 300°. That's the easy part. Hard part is trying to find the right way to configure the firmware to use the stock touch scr…
-
The Hardware section of the ESP32-radio V2.0 Manual states that the ESP32 module is basically an ESP32 on a small print. You used a DOIT ESP32 Development Board.
In the Arduio IDE version 1.8.19, t…
-
### The problem
I try to connect to the Nextion Editor Simulator ("Debug") feature. This is to avoid having to deal with the physical screen (to avoid any damage) and because is just faster to do it …
-
**Describe the problem you have/What new integration you would like**
Hey, i'm trying to use on my ESP32 all three hardware UARTs + a fourth Software UART. This Software UART won't work.
As seen…
-
Library esp8266-oled-ssd1306 and all its fonts do not support Cyrillic.
Translation is not possible.
-
Hi,
I've made it on a nodeMCU board,
It works good but having 22kohm res i have to power it with 3.3v.
If I do with 5v as documented temp goes out of reasonable range.
Makes sense or I'm doing s…
-
After flash the firmware, the nspanel does not connect to the WIFI at all, Is there any location I can check log or debug? on ESP home wen it says flash complete. the panel now boot into ewelink front…