-
Hi @rvdbreemen,
After an OTA upgrade from v0.8.5 to v0.9.0 the Web server became very slow.
After disabling MQTT it got fast again. Re-enabling MQTT makes it slow again.
I've downgraded from v0.9…
-
Would it be possible to add some control over the LEDs?
I have the Nodo OTGW in the clear case + NodeMCU. There are 3 LEDs that flash non-stop, one green one on the board and two blue ones on the …
-
Follow up of issue #84 with OTGW firmware 0.9.1
The DHW enabled bit is now read, but is constantly flipping between 1 and 0.
Use case is still the same.
Setup:
- Thermostat always sets DHW_ENABL…
-
### The problem
This morning I discovered that my HA Core was down after the DST change (NLD located). From the `dmesg` log I conclude that HA core was OOM killed. After reviewing the home assistant …
-
Hi,
I currently use the OTGW with a NodeMCU (ESP8266_NODEMCU), this has a bright blue Builitin LED on GPIO02 (inverted):
https://…
-
HI trying to upgrade the PIC trough the web interface, nothing happens and the telnet session displays this 👍
13:35:43][ 17304| 15968] upgradepic (1251): Action: upgrade gateway.hex 5.1
[13:35:43][…
-
Hi!
I got a version 2.3 OTGW installed between my boiler (Remeha Calenta) and the Toon boiler communication module (ketelmodule). With the latest version (17) I get a pop-up on Toon that there is …
-
### The problem
I am not able to see the status of my MQTT devices, neither with devices connected directly to Mosquitto MQTT broker, nor with Zwave devices connected via the Mosquitto MQTT broker …
-
Hello
I have managed to compile files and uploaded ESP8266 using Arduino IDE.
I can login into otgw.local. When I click **PIC firmware** nothing is displayed, and info “ No version found” at th…
-
UPDATE:
SOLVED!
Issue solved with 2A USB charger and high quality USB A-B cable
After every reboot it works once or twice and then stopped.
PS, via direct serial connection and monitoring on st…