-
In Germany all houses are connected through a three phase power connection. To measure the complete energy usage it is required to measure all three phases. Instead of using 3 ESP8266 and PZEM-004T th…
-
Hi,
just finished investigation about NOT working DS18b20.
I noticed, that if i select f.e. FPIO14=DS18b20 AND GPIO3=ds18b20 then i CAN NOT see any Values.
If i select only ONE GPIO as DS18B2…
-
Hello,
I flashed the espurna firmware on a wemos d1 mini pro, everything according to instructions in the Sensor.h changed so:
#ifndef PZEM004T_SUPPORT
#define PZEM004T_SUPPORT 0…
-
Hi,
I just received a PZEM-004T V3 now with Modbus.
I am using last tasmota all-sensor build ,
TX GPIO1 Serial Out => (62)
RX GPIO3 Serial In => (68)
For me power, current readigs are…
-
Hi all experts,
Now the PZEM-004T is sold in a V3 version with Modbus communication instead of pure TTL.
It means no more Tasmota support :( ....
Any gurus want to try the add ?
-
As we discussed previsously I think we would need some more mqtt config being available by a simple JSON request or via web-ui. Between the changes I would love to see in the BH-PZEM the following fea…
-
There is a new firmware version of the PZEM-004T sensor.
It actualy uses MODBUS RTU protocol. Also now reports power factor and frequency.
It should be great tasmota support it.
[modbus_PZEM-004T…
-
Hallo. I using Tasmota on ESP-01 board with PZEM-004T.
Its works well, but I want to get values such as power factor,apparent power etc. and send to dummy sensor in domoticz. In Tasmota web configur…
-
Hello, I'm using an ESP8266 NodeMCU with two connected PZEM-004t with a custom firmware I wrote by myself. I would like to use Tasmota and I would like to know if it would be possible to configure two…
-
- [x] Searched the problem in issues (https://github.com/arendst/Sonoff-Tasmota/issues)
- [x] Searched the problem in the wiki (https://github.com/arendst/Sonoff-Tasmota/wiki/Troubleshooting)
- [x] …