-
Hello,
I attached both temperature sensor and extnernal bistable switch to sonoff basic.
If bistable switch is ON (loop closed = GND is connected to GPIO1), then after powering off sonoff it won…
-
Source code attached.
Note that it is based of the athombv/node-homey-zigbeedriver: https://github.com/athombv/node-homey-zigbeedriver
In the node_modules folder, the following file has been cha…
-
The Sonoff GK-200MP2-B is a GK7102S based camera that uses the eWeLink app for configuration and control. I tried the readonly and read/write hacks with no success. Unfortunately I don't think there's…
-
### The problem
The devices work file with `total_daily_energy` disabled. But with `total_daily_energy` enabled, they periodically reboot. I added uptime measurement, and it isn't a consistent amou…
-
As eWeLink will stop provide the support and maintance of current APPID & APP secret on Aug 31th 2020.
That means that this project may work improperly.
eWeLink will offer a special APPID and A…
-
### Latest firmware used?
Latest from master.
### Information
Device used: [Conrad Renkforce Wireless socket](https://www.conrad.com/p/renkforce-wireless-socket-indoors-2000-w-1208457)
It's ba…
-
### Latest firmware used?
Using 0.4 Portisch Firmware with Tasmota 6.4.1
### Information
The device is a ceiling fan remote - https://www.mercator.com.au/product/rf-remote-control/
### Sniffed…
-
Support for ESP8285 based Sonoff Basic would be very simple to achieve.
I made a custom build with a minimum of changes, and it works as expected.
Edited platformio.ini changing the env section as…
-
J'ai acquis le module Sonoff SZB-01. J'ai fait l'intégration dans Jeedom. Dans les commandes je n'ai que
battery_level
battery_percent
battery_voltage
manufacturer
refresh
type
![image](http…
HPHVN updated
2 years ago
-
I was curious if the Sonoff SC will be supported by the main Espurna repo? I am using an older version from https://github.com/xoseperez/sonoffsc and miss some of the nice features of the updated co…