-
When I upload MoveAtVelocity bidirectional example, the motor starts moving, but I get "Stepper driver not setup and communicating!" spam in the serial monitor. 1k resistor between rx and tx is in pla…
-
After updating the rustc compiler to `rustc 1.82.0-nightly (8e86c9567 2024-08-01)` from `rustc 1.82.0-nightly (c1a6199e9 2024-07-24)`, serial writes don't work properly any more.
Here is the minima…
-
Hello all,
Although I got some StallGuard values output, the results are hard to interpret.
I have the TMC2209 connected to an Arduino Mega via UART.
I have written a script where the motor acce…
-
# A que parte do projeto esse Issue se refere?
- [ ] Software
- [ ] Hardware
- [ ] Dados
- [X] Documentação
- [ ] Outro
### Reportando um erro
No setor de Partes Eletrônicas, consta 1…
gdmpg updated
4 years ago
-
Hello,
I am trying to make this library work with ESP32-S3 and BIGTREETECH TMC2209 1.3 UART drivers.
https://www.amazon.com/BIGTREETECH-Printer-Stepstick-TMC2209-Heatsink/dp/B07YW7BM68/ref=cm_cr_a…
-
The space under the table should be utilized. Equipment that has to go under the table is:
1. The Plasma Cutter
2. The pump
3. The tank
4. A box with electronics for room for the power supply, f…
-
Hi.
First of all I apologize for my level of English, I probably have more than one fault.
Once the code "StallGuard_TMC2209: https://github.com/teemuatlut/TMCStepper/tree/master/examples/StallG…
-
If the driver of my stepper starts with a resolution of 400, Something needs to change in the code ?
![71ghgGa4WTL _AC_SL1500_](https://user-images.githubusercontent.com/71190522/102350309-65846680-3…
-
Thanks for the work!
Sadly the 28BJY-48 Stepper motor is very low torque and for a little bigger blinds doesn't work anymore. Have you thought about making this plugin work with a more powerful step…
-
Queria saber como se configura Vref del driver A4988 paralos ejes Y1 e Y 2 para un motor stepper de Imax 1.5 A ?