-
Got REM working on a Raspberry Pi 3 Model B Plus Rev 1.3 with a [Four Relays four HV Inputs
8-Layer Stackable HAT](https://sequentmicrosystems.com/collections/all-io-cards/products/four-relays-four-i…
-
Thank you for opening an issue on an Adafruit Arduino library repository. To
improve the speed of resolution please review the following guidelines and
common troubleshooting steps below before cre…
-
Hi, In **Adafruit_CircuitPython_ADS1x15**, inappropriate dependency versioning constraints can cause risks.
Below are the dependencies and version constraints that the project is using
```
Adaf…
-
Customer was unable to configure and verify Qwiic ADC for sample rates between 128Hz - 920Hz, using .setSampleRate() and .getSampleRate(). Asked customer to add further details to this issue.
-
Hi,
Based on reading the docs I set up an ADS1115 with the following:
```
_ads=new ADS1115(_addr);
// initialize the Analog2Digital sampler
volatile bool status=_ads->begin();
…
-
I observe this problem when trying to read voltages using the ads1x15 module, with ADS1115 A/D connected via I2C.
It has four input channels for measuring voltage. When I use just one channel, conf…
-
Hi i am trying to install 4 mic array as per given instructions but arecord -l does not show any device after installation
sudo ./install.sh
Hit:1 http://ports.ubuntu.com xenial InRelease
Hit:2 …
-
**Describe the problem you have/What new integration you would like**
Integrate the usage of an ADS1015, the 12bit variant of the ADS1115. Only some minor changes to do the conversion 14>12 bits…
-
Hi, I just bought an ADS 1015, and I set the data rate to option `1` in the code. However, when I read the serial output with my laptop, the data rate looks lower than the target rate. For instance, i…
-
**EDIT**: In your [documentation](https://wiki.seeedstudio.com/ReSpeaker_4_Mic_Array_for_Raspberry_Pi/), to which your readme also points, you are referencing a different git repository: https://githu…