-
### What happened?
I have tried to connect a new Moes BHT-006GCZB to Zigbee2mqtt.
First permit join on zigbee2mqtt. Then as described in the manual I have reset the BHT. (when the thermostat is off…
-
## What happened
The status of the "on" button is only evaluated for a single actuation.
Pressing the "on" button again will be ignored. The other buttons ("off", "brightness up", "brightness down)"…
-
Hello,
I compiled examples (as they are) in contiki 3.x (DriverLib v0.46593) on different boards (SmartRF06 with cc2650em and SensorTag2.0) and:
- cc26xx-demo is working well
- cc26xx-web-demo is re…
-
If I connect the wired TS0013 Tuya switch (no-neutral) as described and paired it with Zigbee2Mqtt, it turns off again after 2 minutes. But if I remove it from Zigbee2MQTT, it is working fine.…
-
Any tips on SWD flashing a standard Silabs bootloader FW on Ebyte E180-ZG120B-TB evaluation board and E180-ZG120B module?
* https://www.cnx-software.com/2020/04/27/ebyte-e180-zg120b-tb-zigbee-3-0-e…
Hedda updated
3 years ago
-
### What happened?
After updating from 1.40.1 to 1.40.2 or latest, or latest-dev the device SONOFF ZBMINIL2 stops responding after a few minutes.
The switch can't be turned on or off via MQTT or th…
-
## What happened
I have 3 Aqara TVOC devices (VOCKQJK11LM). At first, all three worked fine for about a week. Then, no more updates were reported for one device through Z2M, a few days later …
-
### Board
esp32c6
### Device Description
esp32c6 dev module
### Hardware Configuration
no
### Version
v3.0.0
### IDE Name
arduino ide
### Operating System
windows 11
### Flash frequency
8…
-
### What happened?
I am unable to pair the device to Zigbee2MQTT. It does not show up in the device list and there is no information in the logs.
### What did you expect to happen?
The device is di…
-
### What happened?
When I try to change the config file to allow the new coordinator to be the coordinator for the Z2M I type in tcp://192.168.1.186:6638 and then when I try to start Z2M it fails an…