-
### Description
## Description
If the button "home all"is pressed the code generates (old) gcode and thus throws errors
"Warning: Obsolete use of S parameter on G1 command. Use H parameter instead.…
-
Hello,
i read you can control PSU with M80 M81 Commands with the following configuration.
[output_pin power]
pin: !ar12
value: 0
shutdown_value: 0
How do i know the pin number of my duet w…
-
Ok not really sure if it's spose to be an issue or a request? Anyways, here goes.
From what I understand the Duet 2 line is supported by klipper as of now.
I haven't really been able to dig up t…
-
Since Klipper already supports the TMC21xx family via SPI, I was wondering if there were any plans to support the TMC2660 drivers as well, since they are featured on the Duet 2 Wifi.
-
I'm struggling to run Klipper on a Duet Wifi 1.04 (SAM4).
The Duet is connected through PANEL DUE connector (UART0 on the SAM4) to /dev/ttyAMA0 (PL011 uart on gpio 14/15) on a Raspberry Pi3 b+ run…
-
This is more of a question I suppose.
I'd like to set my bed PWM frequency to 20kHz or more to get rid of the switching sound (it's a 24V MK52 bed clone on a Voron Switchwire).
Does Klipper use hard…
-
Since the Duet Wifi is supposed to work with PT1000 on the thermistor inputs, I decided to try it out.
#1137 Had all the information I needed, but I would always get a math domain error.
Manually ca…
-
Hi!
I have been researching possibility of building 3d-printer without centralized control board (like duet wifi) so that
1) Rpi runs octoprint and klipper.
2) each device would connected via bus (…
-
First, thank you very much for klipper. :)
Second, I'm not sure if this would be easy or difficult, but I found it useful with my duet wifi (when using sensorless homing) to turn the current to mo…
-
There are a few parts in the BOM I have a Problem with
- Duet Wifi = There is only the new version "Duet2Wifi" available, but i red thats not a problem. is that right ?
- Mosquito Mount = is no…