-
Hi! I'm building gnuradio from source as described [here](https://kb.ettus.com/Building_and_Installing_the_USRP_Open-Source_Toolchain_(UHD_and_GNU_Radio)_on_Linux#Building_and_installing_UHD_from_sour…
-
If swig is not installed, CMake still completes normally with no error messages. When make is then run, it gets part of the way through and dies.
-
Hello srsRAN team,
I recently updated srsRAN_Project and after the update, srsRAN-gNB doesn't run with USRP X410. I was able to work with USRP X410 and srsRAN_Project before, but using the same con…
-
Hi there,
is there a roadmap to also support UHD / USRP based SDRs like Ettus B205 / B210?
Thanks!
-
Hello;
I need to detect RF signal with USRP X310. I would like to know how can i connect USRP X310 with our PC in order to disply the RF signal using Python langage; I'm so gratefull if you can sen…
-
When I mute sound by clicking on checkbox or change a volume by dragging of a slider, I want immediate reaction of the software.
Instead, it waits approximately 1 second before action takes place.
M…
Vort updated
8 months ago
-
## Issue Description ##
## Setup Details ##
## Expected Behavior ##
## Actual Behaviour ##
## Steps to reproduce the problem ##
## Additional Information ##
-
## Issue Description ##
Hi community,
I previously had a functional srsRAN setup, but when I attempted to use it again last week, the gNB failed to start. Upon investigation, I discovered that the…
-
### Describe the bug.
When I set my Flipper to "Read RAW", it always misses the first bit of data. This effect is amplified tenfold when the RSSI Threshold is set. It is in all Versions. I've teste…
-
### What happened?
I could not use gr-ettus's rfnocmodtool at GNU Radio v3.10 because could not build with v3.10.
I found that swig has been removed since v3.9.
How could I make rfnoc block for g…