-
## Current Behavior
I flashed a DIY Mini ESP32 SX1280 2.4GHz TX to 3.4.0, 3.4.1, and 3.4.2, but the LUA script from the ELRS Configurator doesn't load in any 3.4.x firmware. The LUA script from 3.3…
-
## Summary
Is there target plans for Jumper T Pro V2 ELRS internal module, tried flashing with T Pro version - module not responding (ElrsV3.lua) hangs.
pagex updated
4 months ago
-
## Expected Behavior
The ExpressLRS Configurator 1.6.1 should open and function as expected after installation
## Current Behavior
After launching expresslrs-configurator-1.6.1, the followi…
-
### Describe the bug
**RX was bound prior to installing on the FC.
I have an iFlight F411 which uses the IFLIGHT_F411_PRO target. A BetaFPV ELRS nano RX receiver is connected to UART2. (I cannot u…
-
@anti-social @peterkrull
Currently we have no way of dumping an extended packet(and specifying the extended dst/src fields). I found three ways of accomplishing this:
1. The `dump` method should ta…
-
## Summary
I can't find this firmware Generic ESP8285 SX127x 900MHz RX on the ExpressLRS Configurator ground station(1.6.1)
I need firmware compiled for ESP8285 + sx1276 that can be downloaded …
-
## Current Behavior
after flight i changed battery and the reciver rp1 went into bind mode by it self.
had to go into the reciver via wifi hot spot and put in the bind phrase again to get it to co…
-
with V3.4.0-RC1-3 Wi-Fi turns on after 60 seconds although AUTO_WIFI_ON_INTERVAL was unchecked when flashing.
I tested on
HappyModel EP Dual 2.4GHz RX
HappyModel ES900 Dual RX
I flashed back t…
-
## Current Behavior
Yesterday, I set my Adiomaster RP1 to SBUS output format. Everything OK, my MSH Brain unit recognize input signal. Today, I power on radio and heli, but Brain not recognize inpu…
-
in 3.3.2 and earlier, wifi starts at my older HM ep1 (with yellow LED) by switching it on by LUA or wait for the 60s timeout without connection to transmitter.
it does not after flashing 3.4.0 or 3…