-
**Is your feature request related to a problem? Please describe.**
Need all registers for these laptopS, all of them share the same OEM (Quanta) afaik, it's an Alienware knock off with either 130w 30…
-
This may be related to #65 and I posted a comment in that thread to describe a set of repeatable steps, which I've updated here based on another experience:
1. Press [Mod] 3 (to switch to a Bluetoo…
-
Per commit a0750943f78cb8f9f55d687086200220a6fa1efc we appear to have joy with DFU flashing of the Longan Nano using a USB-C cable (as opposed to the serial pins):
```
sid@vicious:~/muap/mu$ ./muf…
-
I compiled the kernel module, `insmod`ded it, and changed the comments in the demo, then ran it.
However, I only get `0`:
```
Flash_ID: 0
>>Flash读:从[0]地址开始读入256字节...成功.用时0.001S
Read: 00 00 …
-
## Origin
All source can be directly download from GigaDevice [GD32 MCU](http://www.gd32mcu.com/en/download) support web site at download section.
[gd32f403 firmware library](http://www.gd32mcu.co…
-
Hello, I am currently writing support for these new chips as it appears they are becoming more and more common (not only creality but also bigtreetech). I have this board on Sovol SV01 Pro.
What I …
-
I've been trying to get the example blink programs to run.
Since I don't have a debugger or serial port, I need to use dfu method for uploading.
So I only add `upload_protocol = dfu` to the platfo…
-
Hi,
I looked into why git/main was not working on my bluepill (v1.8.2 works without problem)
When a flash operation is performed (write/erase) the logic has changed to check success
- Before : Wait…
-
I would like to dump the content of the NAND on a router device.
Its a GigaDevice GD5F1GQ5UEYIG, could you add support for it?
[https://www.gigadevice.com/datasheet/gd5f1gq5xexxg](url)
-
Applying the results of the discussions in #34971 and #38657, I propose to add an NMSIS module.
This module is different from proposed in #34971. Reissue this PR.
## Origin
NMSIS
https://githu…