-
Just throws a bunch of errors to command window.
"About" window looks weird http://i.imgur.com/rPgM6Oq.png
And I can't see recently used files list...? So pity if it's gone.
-
There are ~~a lot of~~ hard coded english strings used throughout the source. These need to be pulled out into the language files.
See @i-make-robots' [comment](https://github.com/MarginallyClever/Ma…
-
Noticeable curtaining effect which is new in the past months firmware updates.
![](http://i.imgur.com/LXeBTe3.jpg)
Has anyone noticed this? The top line is intervals of 10 on the manual controls and…
-
The stepper motors are engaged on first movement and then never disengaged if disconnected.
Not a critical issue but it might also be useful to add engage/disengage buttons for manual readjustment pu…
-
![screen shot 2015-05-25 at 1 41 39 pm](https://cloud.githubusercontent.com/assets/4303638/7800477/e4513a9a-02e3-11e5-886d-bc7eba209356.png)
#95 is most likely to blame. ~~I suspect this issue I am se…
-
on very rare occasions the serial comms will drop a single character. The Makelangelo will then try to send the pen holder to an impossible, out of bounds location.
A checksum and a "please repeat c…
-
Can we modify the firmware to read from an SD card, if present? That way it can run unattached from a PC.
-
I checked out the code and it seems that it should be possible to use the current Adafruit motor library. It appears to require configuring the single step mode.
```
m1.onestep(dir1, SINGLE);
```
…
-