-
template not needed. r9m. 2 annoying beeps on crsf connection establishment. this bug was not present on v1.0.0 which is what im coming from
-
Hi,
I am flying a 50cc Extra 260 equipped with the following:
- DA50 with CDI - far from Rx
- 2 LiPo 2S batteries
- 2 FrSky NFC switch, one for each battery
- FrSky XACT servos
- R10 Pro as the…
-
After upgrading from version 1.2 to 2.0.0-RC3, it is not possible to configure FrsSky P9. Settings are not saved.
[Steps to Reproduce](https://youtu.be/2nc4--IKlLA)
Transmitter: Taranis QX7 ACCT…
-
## Current Behavior
The Thor TX module reports inconsistent bad:good packet values in the lua status bar at boot. The two numbers always add up to the packet rate Hz value, but it never seems to se…
-
I made this its own issue as it has to do with how the root check works and not about it being optional.
Please see the documentation for RootBeer under False Positives:
https://github.com/scotty…
gramx updated
2 years ago
-
Using the R9M system ( fully updated at both ends) with the 722-SE board I can't seem to get all channels to respond in the receiver or mode tabs. Channels 6, 7, and 8 are unresponsive but 5 and 9 wor…
-
Hello everyone !
i'd like to thank you all for the hard work you've put in to get the project to where it is!
i just got my ES24TX and tried to update it over the wifi network that's created on st…
-
Hello,
I did install OpenTX 2.2.3 beta, because of the new flex firmware i try out for my R9.
However, i did a fresh install and setup, then did copy the BF lua files over, now when i press Page, …
-
### COR Name
Cecila Lee
### Vendor Onboarding Representative Name
Other
### Your Name
Aaron Ponce
### Your Email
aaron.ponce@agile6.com
### Name of Your Team
PTEMS Platform CMS Team Front-End…
-
We are observing problems with the requests to the GoCardless **sandbox** API. However, requests to the **live API are running without issue**. There have been no recent changes to the integration cod…