-
## Security Priority
- [ ] This is a report related to [Security](github.com/canne/dashboard_tactics_ptyi/security)
## Installation checklist (change to [X] when sure)
I have inst…
-
Trying to get this working on a Pi Zero 2W since it has the same VideoCore IV GPU as an RPi 3, and options.txt has dtoverlay=vc4-kms-v3d by default - but there is no /opt/vc folder - am i just missing…
-
To be able to test stage1 stuff on the open firmware, stage1 must be on one of the 7 sources listed above
and we need a way to remotely replace the stage1 binary
that's where the SPI flash stuff i m…
-
Hi Jardi!
I appreciate your **BYOWS_RPi driver** , working with all sensors, but i would like to develop further.
Are there any solution to connect - to the BYOWS_RPi driver - other DIY sensors …
-
Fresh install on a Zero W. Image written via Rufus on Windows.
Boots fine, I can access the Pi/web UI via an ethernet dongle. `dmesg` output below seems to indicate some kind of issue with the inb…
-
I need help setting up the display please. Have compiled from source w GTK-3 on Clockworkpi uConsole CM4,
`sudo pigpiod`runs fine no errors during test but when I run `piscope` I get the following:
…
-
I added `dtoverlay=pwm-2chan` to `/boot/config.txt` on a Raspberry Pi 5, but` lsmod | grep pwm` does not show any output.
Also there is no pwm-signal generated either on GPIO19 or 18.
-
SKR2 Documentation indicates connecting Raspberry Pie for the SKR 1.4
The two boards appear to be completely different.
No row of pins at the edge of the board?
-
the new assist_satellite entity in home assistant is not feed correctly.
When the message is finished the state keeps responding for a long time.
I have one system that goes to listening when the …
-
The Raspberry Pi (Rpi) Camera can be leveraged with the Record-Activity. It has multiple use cases, such as tracking and monitoring, recording etc.