-
I am testing this with the JBtek USB to RS485 and just an Intellichem connected to it. I have no other piece of equipment.
I always get the message: "INFO Serial port recovering from lost connectio…
-
I have an Intellitouch i5+3S system with solar water heating panels, with a valve that is actuated based on solar temperature. The Intellitouch display (Menu/Setup/Equipment/Solar) has Water Solar Pre…
-
Any chance you could add mqtt topic for the pump watts for the pentair-screenlogic project?
-
### Expected behavior and actual behavior
Low Flow warnings aren't shown as cleared even though the SWG (Pentair IC40) LEDs say flow is fine
### What is actually happening (screenshots are helpf…
-
Hi @sfeakes,
I have just updated to the latest release and noticed my switch in home assistant won't show off status. Always returns to on once switched. The actual pump turns on and off as expecte…
-
I have the iChlor connected to intelliconnect. With intelliconnect I can see the water temp, so I tried to figure out where this data was coming from. Here is what I found
`10 0210 1600 0f49 000…
-
Hi I do not know if this is the best place to make a question, but I can't find any other way.
I'm building a small pool, 40m3, and I would like to get the info of the chlorinator to publish it in…
-
First I want to say I love this Library! totally awesome.
Per our previous postings...
I would like to make a feature request for Set Control for the Salt Cell Output.
User Story: I have …
-
loaded up version 6 went very well -- but neither of my heaters show up in the states array:
![image](https://user-images.githubusercontent.com/4008317/88595413-8103ca80-d028-11ea-968f-06fdd0d77e8…
-
Intelliflo VS pump is off, but flow is reported as 55 GPM in state/all JSON
### Expected behavior and actual behavior
http://myserver:4200/state/all
expected: GPM is not reported or is reported a…