-
I don't have a formalized test plan but tried a number of things on my solderless breadboard set up.
exercised input pins:
- x, y, z limits work correctly.
- door works
- reset/panic works
- p…
-
I'm working on a similar project but with 3 or 4 wheels. STM32 can support 4 hardware quadrature pulse counters. Wondering if this is something you have considered? Also wondering how the physical …
-
Current behavior AFAIKT with a bit of testing.
M3/M4 will start all spindles as long as their respective S codes are already set, adding a $ with a number will start a specific spindle.
M5 stops…
-
Hi experts ;
I need a software for cnc wood lathe 3 or 4 axis,
Any suggestions ?
Thanx for helping .
-
Hi Guys.
I have DIY laser cnc machine
I’m using arduino Uno and CNC shield with GRBL 1.1h and Lasergrbl software.
The issue is Z axis homing is not responding
Only y and x moving to homing as no…
-
Mr Clough,
I have Grizzly G9972 lathe. I have been trying to get the ratio for threading right. So far no luck.The Configiration.h file reads:
Encoder uses 1:1 ratio from the spindle(45T to Idler 45…
-
Finished up an install, and noted that the feed rate was way too slow, and when doing some initial testing of threads, double checking my setup several times, ie 1:3 gear ratio, on a 1000 pulse servo,…
-
I have been scratching my head for over a week now on this issue.
When ever I try to home the Z-axis, if the limit switch is not triggered within 7mm of travel, I get ALARM 9 triggered.
Every a…
-
Hi there! I realy need some help. I connected everything together and the closed loop stepper does not move. The stepper i chose is this [https://www.ebay.co.uk/itm/DE-12N-m-Nema34-154mm-Closed-Loop-…
-
Hi every one, I'm using the mega 5 axis on a experimental cnc.
Normaly i use a UNO with a cnc shield and work perfectly.
I use the $1=255 to have all the time the stepp motors with power (I have a f…