-
### Description
When I boot up my SKR 1.3 Controller with the TFT35 V2.0 Screen (Touch-Mode) my Z-AXIS always moves up "some" height. It's definetely more than 10 or 20, feels like it's traveling the…
-
### Bug Description
I'm experiencing radom freezes when printing with Octoprint over serial connection.
Using SKR 1.4 turbo, RPI4, directly connected to TFT serial interface (SERIAL_PORT 0).
Runn…
-
I've been talking with @Fragmon a bit about their Kobra work today and an interesting find came up: Bltouch probes don't work with the clock speed set to 200mhz. Flashing a 200mhz config shows a 168mh…
-
btt_skr_1.3_map.h - default probe pin is 0.12, should this be 0.17?
(might just be me, but I cant find a 0.12 on the lpc1768)
-
Initial marlin configuration has **Z_MIN_PROBE_PIN** and I don't see in manual what should it be. Currently my BlTouch doesn't work because of that I guess.
-
Sept. 9, 2020 edit: With https://github.com/MarlinFirmware/Marlin/pull/19279 and https://github.com/MarlinFirmware/Marlin/pull/19281, `EMERGENCY_PARSER` is now fully supported on `STM32F1` (SKR Mini 1…
-
I am new to Modbus communication, and I am trying to learn it. I am using LPC1768 as the master and the Raspberry Pi as the slave for Modbus communication. Everything is working fine when I use the se…
-
Please bare with me my terminology is probably all wrong (frameworks are above my pay grade!)
With Marlin when you build (for any system) one of the stages it goes through is
`.platformio/packa…
-
I've spent hours working with FLSUN to fix the firmware for my custom QQ-S Pro with an MKS Robin Nano V3.1 and a TS35 V2.0.
I have the Homing fixed except, if I offset any axis by a small amount ma…
-
Buys!
My setup:
Marlin 2.0 bugfix based firmware + Bigtreetech SKR 1.3 controller board (LPC1768 processor) + 2.4" TFT controller moduler from Bigreetech (TVT24-V1.1).
The facts:
SKR 1.3 control…