-
I've programmed a fresh STM8S with provided code, but it looks like there is no response from board when it starts or when I write to it through serial port. CC (yellow) LED is always on.
I've tested…
-
Do you have some insight where it would be best to pull of a couple of GPIO pins, (or possibly just 1, as both output for trigger, and input for echo) to drive a low cost ultrasonic ranger sensor? I g…
-
Several users have had difficulties getting the W1209 serial communication to work, e.g.:
* https://hackaday.io/project/16097-eforth-for-cheap-stm8s-gadgets/discussion-90018
* http://forum.hobbycomp…
-
The README states that the OS is for ARM and STM8, but I don't see any STM8 Makefile or STM8-specific code. Will there be STM8 support? If yes, via which compiler(s)?
Philipp
-
problem is the lack of a __weak attribute in the compiler. No idea how to allow for a user-defined function that is only called if it exists without generating a linker error.
-
I'm wondering if you think it's possible to get this running on the ST-LINK that comes with the stm8s-discovery. http://st.com/stm8s-discovery The ST-LINK usb programmer for the stm8s has a STM32F10…
-
After a power cycle my test XH-M188s don't respond with the stm8eForth prompt, or apparently work at all. Sometimes a reset either with a pushbutton or the st-link programmer will bring the console ba…
-
This little project gained more support from users, and there are now minimum requirements on the code quality: at least unit tests need to be performed, and regression tests as a part of the release …
-
; 2/ ( n -- n ) ( TOS STM8: -- Y,Z,N )
; **Multiply** tos by 2.
-
```
Arduino.mk Configuration:
- [AUTODETECTED] CURRENT_OS = MAC
- [USER] ARDUINO_DIR = /Users/k/Documents/sduino/sduino
- [USER] ARDMK_DIR = /Users/k/Downloads/…