-
Hi, i have these new Daly bms for home storage:
https://www.dalybms.com/daly-smart-bms-home-energy-storage-lithium-battery-pack-8s-24v-16s-48v-100a150a-bms-product/
![家储保护板_011](https://github.c…
-
Hello,
I'm trying to install your firmware onto the bbs02 controller (new controller from this year). however Following the instructions, I'm unable to even find the mcu. after unpotting I can confir…
-
Would it be possible to show the SOC by the % voltages given in the settings list? Instead of relying on the coulomb counter in the BMS? I often use the BMS just for charging only and this is therefor…
-
I've been making some additions to GRBL to add make it interface with STM L6474 boards, to provide stronger drivers that the typical circa 2A drivers often used.
This has added about 1.5K to the com…
-
Hi. I'm trying to connect to an EASUN battery.
Link to battery:
https://www.easun-energy.com/products/easun-5kwh-10kwh-powerwall-48v-lifepo4-battery-bms-communication?srsltid=AfmBOo
![bms-stick…
-
### Is your feature request related to a problem? Please describe.
_No response_
### Describe the solution you'd like
Hi,
I currently have 2 HM-600 installed. It would be great if it's possible to…
-
### The problem
Using ESP32dev and MCP2515 with logic level shifting. All working OK. Also ESP8266 & MCP2515 used to monitor CAN messages.
Getting serial feed from Victron Smart Shunt for batter…
-
Hi my inverter is this: infinisolar
https://www.solarpower24.it/negozio/inverter/inverter-hybrid/sp24-infinisolar-v-iv-twin-6kw-48v-inverter-solare-ibrido-off-grid-isola/
Have PI18 protocol.
I…
-
hi ,
what do you think about these mod to be able to have a better reliability and capacity in comm ?
VSS is the voltage from the other module, requested by the new opte 6N137
Module v440:
![im…
-
Hi
I have the docker installation running and MQTT is sending data, but all only config data, no values.
inverter_poller shows real data.
What do I need to configure to get real values for each t…