-
# Introduction
Our team at the Laboratory for Atmospheric and Space Physics (LASP) at the University of Colorado Boulder (CU) recently completed the integration of the Colorado Ultraviolet Transit …
-
Hi,
I am currently modifying the bootstrap example source code and would like to use the following classes:
1. Encoder_polar
2. Decoder_polar_SC_naive
3. Encoder_turbo
4. Decoder_turbo
Howeve…
-
I ran a test with blocksat-cli sdr over 7 hours and came to the conclusion that the Bitcoin blockchain cannot be permanently synchronized with blocksat-cli sdr.
The blockchain had previously been s…
-
Hi Aang I am trying to use Live Decoding on Satdump for Meteor-M2 however I am unable to get good signal for the demodulator to start working. If I use SDR++ Meteor demodulator on the same machine it …
-
Hello,
I am studying the 802.11 protocol and your module has been very helpful in my learning. I am working on a project to locate access points by MAC address and signal strength using a yagi …
-
@noc0lour any idea?
https://ci.gnuradio.org/buildbot/#/builders/34/builds/9
-
**Steps to reproduce**
My software use "hackrf_start_rx" for 10 seconds and then stop,
result = hackrf_stop_rx(device);
result = hackrf_close(device);
hackrf_exit();
after 5 seconds, then r…
-
The new IC9700 IF output really decodes stunningly well in FoxTelem (set for 48KHz IQ mode and using the IC9700 USB codec for input). But it requires some hackery to make it work. I'd love to see s…
-
EDIT: I have just found out about #208 so I am closing for now - I still didn't resolve it but maybe I will find some clue in there.
Hello,
first of all thank you so much for your work on the impl…
nlhnt updated
3 years ago
-
Hi,
I’ve recently started working on a project trying to replace some satellite baseband equipment with a software radio. Firstly I wanted to say that this project, the articles and the GRCon talks…