-
When installing the deb for the Linux 64bit release on Ubuntu 12.04, the software requires libv8-3.14.5 and Ubuntu 12.04 currently runs libv8-3.7.12.22.
When pulling the source and building, runnin…
-
I think a text editor built inside CAMotics to edit TPL files would be a nice addition. Editing the TPL file outside of CAMotics and recalculating the paths works so you don't have to reload the file…
-
Also, update this page when fixed: https://camotics.org/#missing-linuxcnc-codes
-
I get this error when trying to open with Gbrl Controller
No data from COM port after connect. Expecting Gbrl version string
I ran the Uno shield and had no issues with hardware, all motors workin…
-
All my CNC files are on a network share, mapped as a drive in Windows. CAMotics doesn't display or let me choose anything but the C: drive. This is a fundamental problem.
-
Hello,
I am giving a try to Xubuntu 14.04. And fall in the same case as earlier : the output is not displayed as expected whereas the file used is the same (https://mega.co.nz/#!Z4x0iaLI!0w4WETAtrs…
-
The files below are supposed to mill three slots in a workpiece, using three different tools.
- [testsetup.xml](https://github.com/digmanwaves/misc/blob/master/OpenSCAM/Tool-selection-not-working/tes…
-
Hi,
I'm looking into PCB milling, and can figure this out :
I generate a GCode file with either pcb2gcode or FlatCAM [Flat CAM in folllowing case].
I want to verify it in CAMotics, however It di…
-
I can open some but not all nc files, Files created by HeeksCNC are ok but not those by Gcodetools add-on in Inkscape.
-
Hi,
I'm trying to build CAMotics under Fedora 20 and I am getting following erros :
nuptse@nuptse ~/Workspaces/workspace-CAMotics/CAMotics (git)-[master] % scons
scons: Reading SConscript files .…