-
A bit of an **introduction** to the issue.
GW uses the actual NAND size when creating/booting emunand. rxTools and (previously)CakesFW boots these without issue, except for guys with 2DS with N3DS NAN…
b1l1s updated
8 years ago
-
GhostFAT requires unit tests
GhostFAT is quite complex (file systems are inherently complex), and is critical functionality relied upon for updating devices. As seen with the RPi Pico, sometimes …
-
#### Expected behaviour
Righ click on a file or folder
The dialog appears AND shows even the birth of a file
#### Actual behaviour
no birth of file/dir is shown
#### Steps to reproduce the be…
-
Re-report (with log file) of crash when trying to launch Mu Editor from Disk Image (since it cannot be copied onto the hard drive. FYI: Trying launch it from an external USB Stick with a FAT16 file s…
-
I'm using the SdInfo.ino sketch and I've formatted the 1GB micro sd card with the [official formatter](https://www.sdcard.org/downloads/formatter/). Here's the full output of the sketch:
```
SdFat …
-
```
What steps will reproduce the problem?
1. Create 32GB NTFS USB Flash drive or FAT16 512MB flash drive
2. Try to access near end of disk using batch file (see below)
cat --length=16 --hex (hd0)963…
-
```
What steps will reproduce the problem?
1. Create 32GB NTFS USB Flash drive or FAT16 512MB flash drive
2. Try to access near end of disk using batch file (see below)
cat --length=16 --hex (hd0)963…
-
I have been having difficulty in implementing this on the multicomp. The code runs except for reading the sd card. I am using a 1 GB sd card formatted for FAT 16 and it appears not to get the boot blo…
-
Hi,
I am trying to run your AvrAdcLogger example code. But whenever I run the code I am getting the error **"sd.begin failed"**, but when I uploaded the ReadWrite example code from Arduino IDE it w…
-
⚠️ Thank you for reporting an issue!
Before we go any further, understand that I probably won't be able to fullfil feature requests.
Feel free to report what feature you'd love to see, just don't …