-
I tried flashing the precompiled firmware on Windows,
the flashing tool gives no error and finishes cleanly.
However, connecting via COM just repeats:
```
rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (…
-
I have a loop after config the JSON and Wi-Fi password without OTA. I went up several times before but now I get this error:
I'm using esp8266 Nodemcu, MacOs Catalina, esptool version 2.8
```
...
…
zkSac updated
4 years ago
-
Hello, I'm quite new at this, I'm pretty sure I followed all the steps carefully… any help would be greatly appreciated!
I used a very simple existing JSON example just to test it out:
`{"c":{"b":…
-
Hello, when I try to enable a e1000 PCI device I receive this error:
```
make run ARCH=x86_64 NET=on LOG=info
Building x86_64 kernel
warning: use of deprecated item 'sync::condvar::Condvar::_wai…
-
Hi all,
I have updated all my Shelly 1PM and they work fine with HomeKit, but for one of them I need to revert back to the original firmware because I need to keep Alexa compatibility.
Is the firm…
-
Hi,
I'm incredibly excited by what you're doing and all your tutorials! Thank you in advance!
Please note, I've been working with ESP32 chips for some time, but always via the Arduino IDE, so t…
-
Hi maccoylton!
Congrats for your great work! Could you help me?
I'm little bit newbie regarding building the firmware to flash de sonoff. I tried to install several SDK's but couldn't make the .…
-
First of all, great idea and great job on this so far!
I had a spare Shelly1 around so I flashed it back to the stock Shelly1 firmware and tried the procedure once I had it on my network. I had …
-
I've just started seeing the following when pairing after building the new esp-button based button example. Does this indicate a hardware error? The device (Sonoff Basic R2) was previously working fin…
-
After using vagrant to upload the firmware to the Nodemcu, the nodemcu doesn't show up in my wifi list, and the onboard blue led is blinking.