-
I have been using 6lbr for couple months without any problem, but somehow it stopped routing udp packets to the sensor network (aaaa::/64) . I am able to receive UDP packets from the contiki nodes.
I…
-
Hi,
I have been working for some time now with 6lbr. My setup is basically a RPI2 which acts as a border router and in which 6lbr is deployed. The RPI2 has connected to one of its USB ports a CC265…
-
Just installed deCONZ v2.04.66 on my Raspberry Pi with RaspBee firmware 0x26130500.
All my seven Hue dimmer switches report `config.reachable` as `false`. They show as normal grey nodes in the deC…
-
hi,
I bought a set of LoRa development from SEMTECH, my end-device is SensorNode, I flash the example code of Ping-Pong in my device from DFuSe tools.
I enabled the USB_CDC to check the log from UAR…
-
根据ST库描述:At transmission end of transfer HAL_UART_TxCpltCallback is executed and user can add his own code by customization of function pointer HAL_UART_TxCpltCallback,只有在发送数据后才进入HAL_UART_TxCpltCallbac…
-
I'm currently trying to use the LoRaMac node on STM32l152 Nucleo board.
I've migrated the project to Keil µVision V5, as this MCU is not supported on V4 ( stop at L152RD). This has required few chang…
-
-
There are a lot of changes in master that are very sloppy.
Looking at:
Commit: 63bab8e7470d6685a6c24145f7d5c9175a678ee0 [63bab8e]
Parents: c47feaefd0
Author: Daniel Jäckle daniel.jaeckle@stackforce.d…
-
Hi MySensors Team,
thanks for this great library.
After some playing around I started to develop software for my sensor nodes with the MySensors lib. Today I realized a problem which occurs when I am…
-
Hi,
Thanks for the great HAL update. Only I now have a problem at line 307 in gps.c
`uint8_t GpsParseGpsData( int8_t *rxBuffer, int32_t rxBufferSize )
{
uint8_t i = 1;
uint8_t j = 0;
ui…