-
I have four sonoff mini diy. They were delivered with the 3.3.0 firmware release built in.
I managed to set diy mode (with jumper) and update tasmota firmware for three of them.
But when I connect…
-
### What happened?
When pairing a SMSZB-120 HW version 5.2.0 I get TABLE_FULL during configuration
It happens on my **zstack CC2652P (ZBDongle-P)** and on **ember** on the **SLZB-06M**.
On ezsp…
-
### The problem
Using the standard 433mhz remote that comes with the D1 Dimmer, turning the lights on works fine. Dimming works fine with the buttons.
However, when turning the lights off with t…
-
### Problem description
No entities added when pairing Garden Hose Water Valve TS0601 by TZE204_7ytb3h8u.
### Solution description
Support pairing the TS0601 valve with entities to control the valv…
-
### What happened?
At some point my zigbee network became non-functional, I went to restart Z2M, but it now refuses to work due to inconsistency of configuration. At the same time it reports
` Confi…
antst updated
3 months ago
-
Hello,
I have Sonoff S31 with Tasmota 6.4.1.
![image](https://user-images.githubusercontent.com/42678689/52179456-e024ae00-27a8-11e9-81b7-57557959dc89.png)
The plugin work well in Homebridge b…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Describe the bug
I have installed Homebridge on a Mac OS Monterey. I have Mosquitto and Zigbee2MQTT configured…
-
### What happened?
Home Assistant user. To ensure a light is really off, I usually switch a light off, wait some seconds and then switch the light off again without further checks if it's still on …
-
### Problem description
The blind motor is detected but no controls are present.
### Solution description
I would like it to have cover controls as per my other blind motors (TS0601 by _TZE2…
-
Bought recently a Sonoff minir3. Did the configuration, found out that in order to get info, the deviceid should not be sent as it would return status 422.
So without it - on the info call /zeroconf…