-
Hi,
i compiled and flashed on a ESP32-WROOM-32, it's booting but there is constantly output flowing over the screen i cannot press W + Enter or A nor it's doesn't react to the cables shortended bet…
-
### Hardware:
Board: Wemos D1 R32
Core Installation version: Don't know
IDE name: Arduino IDE
Flash Frequency: 80Mhz
PSRAM enabled: no
Upload …
-
### The problem
The issue starts to happen after upgrading to ESPHome 2024.5.0.
My LD2410 presence sensors are working fine with version 2024.4.2.
The firmware compilation log is attached: [log…
-
Het lukt mij helaas niet om Ducobox te ‘joinen’.
Na op de ‘joint’ knop gedrukt te hebben, zie ik wel:
- messagereceivedcounter: 25
- messagesentcounter: 5
Maar de network id en device address…
-
Hello,
Thank you for your work.
Everything works with an regular ESP32.
On the other hand, I'm tearing my hair out with an ESP32S3, whatever the model: I have two of them and they both refuse t…
-
Yeap, It's all up there
-
I have a weird issue. Title kinda describes it all. In my program I'm loading I cycle through red, green, blue then show some text in white. The Red shows up nice and bright, the green shows up but…
-
I have a long strip available for free and I'd like to know if it's possible to easily adapt this project to use that full strip of 5050 as at least 1 big RGB Led in this project ?
-
I am posting this to describe my experience in trying to get 5 RFID devices (MFRC522) to work at the same time using 1 Arduino.
This is also relevant to these posts:
https://github.com/miguelbal…
-
**Carefully written Issues are more likely to be given priority.**
**丁寧に記述された報告は優先して対応される可能性が高くなります。**
## Environment ( 実行環境 )
- MCU or Board name: ESP32-S3-WROOM-1-N16R8
- Panel Driver IC: …