-
Hello, I have an M5Stick-C-Plus 2, SD Card Reader (https://www.amazon.com/Virtuabotix-Reader-Writer-Arduino-Microcontrollers/dp/B0089SYU9C) and a 16 GB micro SD card (FAT32). I connected the SD Card R…
-
Can I use an ESP32 for this project? If so, what changes would I have to make?
Thank you - Rowan
-
I bought and soldered all the pieces, was able to flash the firmware, and all looked good. But almost no key worked, and the ones that triggered a key press was doing it bad (on repeat, multiple chars…
-
Für eine Person mit einer GND werden in der Administration 52 Dokumente angezeigt. In jedem dieser Dokumente besitzt die Person die GND Nummer. Andernfalls würden im Personen-Management 2 Einträge ang…
-
### Orange Pi Zero 2W
![image](https://github.com/PicoPlanetDev/OPi.GPIO/assets/36418285/f22359e0-3066-43e1-8c52-70f53ee2816f)
Orange Pi's new model Zero 2W using Allwinner H618, almost an alternati…
-
## Hardware
* [x ] ESP8266
* [ ] ESP32
* [ ] Raspberry Pi
Modelname: ______
Retailer URL: ______
### nRF24L01+ Module
* [ ] nRF24L01+ you verified this is a **Plus model** capable of …
-
It would be very helpful to be able to inline a connector or a cable into a connection!
```
connectors:
X1:
type: D-Sub
subtype: female
pinlabels: [DCD, RX, TX, DTR, GND, DSR, RT…
-
A slide potentiometer has a carbon strip with pins at the ends. A slider moves along the carbon strip.
In the documentation is this picture. It shows the slider at it lowest position.
![afbeelding…
-
I have a p2.5-96x48-1515-24s-a1 display with FM6124D chips . but i cannot get it to work.
I have
R1 | G1
B1 | GND
R2 | G2
B2 | GND
R3 | G3
B3 | GND
A | B
C | N
CLK | S…
-
Cell # **255** in **ONE_FIVE_LIB** has a constantly on transistor, M0001, but is not identified as non-minimal cell
```
M0001 OUT01 VDD N0001 GND NMOS
M0002 GND IN001 OUT01 GND NMOS
M0003 VDD IN00…