-
I have updated to 1.2.7.
Unfortunately all printer are failing after some while because printer is stuttering (nozzle does not move for some seconds).
In the printing terminal i can see "Display i…
-
I'm running the latest CNCJS with Rambo 1.4 with the Marlin firmware sent directly from V1. Running CNCJS on a pi. I connect to it fine, but I can not job it with the buttons. I know this was fixed in…
-
Before I go off and buy one, does anybody know if grbl will work on the Arduino Uno Wifi with a grbl shield?.
It appears to be an uno clone with the following differences.
https://store.arduino.c…
-
Hi,
I saw the project, but could you please provide me more information?
Do you have some instruction or demo sketch to show how to use it?
Regards!
-
hi again
first i would like to say that i didn't changed this line of code in notif.cc:
aci_state.aci_pins.interface_is_interrupt = false;
cause otherwise i couldn't even connect or pair my devic…
-
```
What change would like to see?
I noticed that the Liquid Crystal library is performing amazing delays of
thousands microseconds instead of reading the busy flag. Why don't we use the
busy flag, …
-
Would be nice if there are any pictures or part names for the used boards as the aliexpress links are somewhat dead
maybe you can add a folder with pictures of every part used?
The sensor itself…
-
Hi, I hope to be in the right side, I like to do an QR application for arduino mega with lcd 3,2 touchscreen, I would like insert text from serial input and convert it in QR code, I'm looking for an …
-
16:11:07.365 -> Read Registers on MCUFRIEND UNO shield
16:11:07.412 -> controllers either read as single 16-bit
16:11:07.412 -> e.g. the ID is at readReg(0)
16:11:07.459 -> or as a sequence of 8-bi…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…