-
Repeated the grbl_esp 32_cnc_controller v1.2.1 Board. I Use a CNC engraver with the ability to connect a milling cutter and a laser. When using the relay to switch the router in the firmware we use pi…
-
for stuff like voltage divider calculator
-
The red cabinet next to the mill is too small, overfull, and disorganized. It would be great to obtain a larger cabinet at some point. A few things to improve in the meantime:
- frequently-used it…
-
Is a Case manufacturing like https://www.wiphone.io (basically an aluminum profile with two plates, eighter also aluminum or plexiglass) feasible? Does anyone know a company that does somethin kline t…
-
There should be an option to not probe points where holes have already been drilled. One way to achieve this would be to check whether the probe point coincides with a hole and either skip it or sligh…
-
I have candle running on linux mint. I have a few issues I can not see the visualizer its just a blank screen with cursor moving, 2 it stops on me was almost like resetting the port so I removed a usb…
-
Issues like this arise, and can be dangerous in a milling context. Ideally, overhangs would be ignored in this context. The issue is finding a performant way to test what is an overhang vs what is n…
-
I am very happy with the [cnc](https://github.com/cheton/cnc) interface to control our Stepcraft. There are a few problems:
* Everyone needs to install and configure it.
* The room is quite cold, no…
-
Hello
I wanted to ask if it is possible to use the TinyG Controller with Chilipeppr to determine the Z hight of a work piece as well as the corner XY of it.
I've found this https://github.com/synth…
-
Super nice machine principle! I am curious to the sheet steel and honeycomb cores you describe. Could you share some links to vendors or images?
It would be interesting to see if we could CNC mill …