-
Just set the "set boiler warm tap water" to "off"
result was that my boiler went to a "5H 268" state - something like a "Relais-Test" - not sure.
What does the Tap-Water function mean?
-
I have just installed Kees device at version 1.9.0 and connected it to the EMS bus in my Worcester Bosch Greenstar 24i boiler. I seem to have the same issue that Higgy identified in issue #60 . When I…
-
I would like to be able to set the temperature x degrees higher than the current temperature, as a way to make sure the CV will start heating in order to manage zonebased heating scenario's for other …
-
Community!
As I have a Nefit heatpump running I'd really like to read this machine. I've been using Proddy's code and it gives a lot of insight. However, dealing with a different thermostat (Nefit …
viimD updated
5 years ago
-
Hello,
I've configured my config file as the following:
{
"bridge": {
"name": "Homebridge",
"username": "XXXXXXXX",
"port": XXXXXX,
"pin": "XXX-XX-XXX"
…
-
Since a few weeks I get the error like below. I need to restart the easy-server to solve this issue. Unfortunately I cannot find a reason for this.
I run it on Windows Server 2016
```
(node:8892) U…
yvelk updated
6 years ago
-
When setting the thermostat to 18 or 20 degrees form my iPhone (iOS 12.0.1) or Mac (10.14), the thermostat is off by 0.1 degrees, so 17.8 or 18.1 or 19.9.
Running on a Rasperry Pi 2
node.js v10.12.0…
-
The `nefit-easy-http-server` package has been updated again, could you update the docker image accordingly? The current 4.x version has some problems with connectivity to the Bosch/Nefit backend; it c…
-
Installed using npm command and after starting server a SyntaxError is reporterd
SyntaxError: Unexpected token c in JSON at position 0 at JSON.parse () at pending.(anonymous function).send.then.res…
-
I bought a ZigBee switch Ksentry KS-SM001 https://ksentry.manufacturer.globalsources.com/si/6008837134660/pdtl/ZigBee-module/1162731630/zigbee-on-off-controller-modules.htm (not arrived yet).
This sw…