-
I am measuring temperatures in my beehives.
Setup: cubecell-AB01, EU868, ABP, ADR=off, UNCONFIRMED uplinks, measurement every 15 minutes, deepsleep in between. My own Things Indoor gateway handles …
-
I have the Adafruit M0 LoRa feather, and I am very new to LoRa and LoRaWAN.
I've cloned the latest master branch of this repo and made a few changes:
1. In 'config.h' I've commented the line for E…
-
Hi,
I am using ESP32, RMF95, and sentrius rgxx gateway. I have experienced a very low success rate. Most of the time, Arduino thinks it is successful, but I only see activation on The things netwo…
ghost updated
4 years ago
-
In the TTN Mapper database there are invalid measurements recorded from LGT-92 devices. These invalid measurements are reported at location 24.35,24.35.
Please use 0,0 as a placeholder location wh…
-
Prepare SD card for RPi. Including documentation of installation process and scripts (there will be 2 of GWs - make it automatic as much as possible :wink:
-
Hi,
Sorry if this will be a basic question, but I spent several hours on this and could not find a solution.
Basically, I use the commen Heltec lora board and want to send to TTN whenever a RF…
-
I tried to install ESP -Gateway -v5.0 on Esp32 TTGO board. you can see the output below.
Rx window and downlink is not enabled. please see the pic1.
The ttn-abp node showed in the IDE has not lis…
jpunn updated
5 years ago
-
Hi
I tried your Alora , unfortunately the provided sample code stops executing when new data from TTN arrives. Error message "Your app has entered a break state, but there is no code to show becaus…
-
Hello,
I know that this library works with the backend The Things Network, but does someone know if this library can work with other backends as Loriot?
I would like to use this library with my …
-
## What are the steps to reproduce this issue?
1. I send a tx with confirmation with 915.2MHz
2. TTN receives ok and shows the frequency downlink wrong (869.525MHz)
3.
## What happens?
I'm …