-
This is to report the calibration factor for **DS3-L.**
I did bench measurements with DS3-L connected to a power supply in cc mode. AC power was recorded with a LMG450 power meter.
DC voltage was se…
-
Hi everyone!
I just received my nodeMCU and CC2530, Flashed "ESP-ECU_v9_3" and "CC2530ZNP-with-SBL.hex" for reading out my APSystems QS1.
In webinterface, I can't save/pair any inverter. Is the …
-
I tried adding my ECU-C to this. The ECU-C is connected to wifi when I go to add the device I get "Can't connect to ECU, check log"
The log is attached below.
This error originated from a custom…
-
Updated HA from 2021.12 to 2022.2 and this plugin from the versionless 2022.1 to the current 1.2.11 via HACS. Now am unable to configure the plugin (was working fine via YAML) When I add in the wifi…
-
Hi,
have installed dbus-mqtt-devices latest version on Cerbo v2.91.
Pvinverters will be registered and are listed as devices in VRM with deviceInstance number.
I can also publish values to them an…
-
I have an ECU-R (Article No. 209018) running firmware ECU_R_PRO 2.0.4. Using the integration version 1.1.2 works just fine on a wired connection (I have not tried wifi).
After upgrading the integra…
-
Hallo Lukas,
besten dank für den schnellen Fix, leider passen die Werte für den HM600 noch nicht.
Für den HM350 wird noch der CH2 angezeigt.
Bitte um kurze Anleitung wie per Remote auf die Konsol…
-
I have an ECU-R-PRO which I can access using the hotspot button.
I downloaded the master branch as 3166ad4 and installed it on HA 2022.1.
When I try to set it up I get in the interface:
`[%ke…
-
Is it possible to make the poll rate adjustable. I only have one DS3-L and would like to see a more frequent polling of the inverter. I've changed the pollrate to 60 seconds which works perfectly. Onl…
-
Hello,
I'm not able to see the `sensor.apsystems energy day `in the energy dashboard. How can I fix this?