-
### Steps to Reproduce
1. Set the hook on Autolevel
2. Press the Save button
3. Go to Terminal
4. Write M501 in terminal
5. Go back to EEPROM and u see the hook is gone
Happens also if u t…
-
For some time, I have been looking into ways of improving the current resonance test offered by Klipper, which runs vibrations of different frequencies and measures the printer response. I had some ri…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Installing the new firmware from SD card, my prints stop after the first layer, the pri…
-
Hello everyone, I have an issue with klipper. I am not using it for 3D printing. I have designed a custom hardware. It consists of large heater plate switched by a MOSFET and reading a TCN75AV0A I2C…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Just installed an SKR 3 (normal one, non-EZ) with the STM32H734 chip with TMC 2208s on X, Y, …
-
### Is your feature request related to a problem? Please describe.
Some Chinese processor boards have switched to the GD32F103 which is an STM32 clone that is pin compatible and almost identical, but…
-
Trying to install firmware_CR10Smart_DW7.4.6 but printer doesn't turn on.
Screen firmware went ok.
I have the CR-FDM-V2.5.S1_100 motherboard.
Can't find if this firmware is compatible with this …
-
Not sure this is the correct place for this but I believe I have tried all options when compiling. I have a Voxelab Aquila G32 and I can take you pre-compiled which works great. I just wanted to tweak…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
My SD Card slot is marked "C" which means the driver for the motors is HR4988. However, in th…
-
### Description
Can we add an option for HR4988 drivers on the v4.2.2 board?
all the other driver options seem to be present including a workaround for the TMC2225 and TMC2226 drivers where …