-
It's would be my first vase after switching to this firmware, but it didn't go well. The printer pauses making a lot of blobs on the print, when I use the spiralize outer contour feature of Cura (vase…
-
Hello,
I have been following the steps as laid out in https://github.com/Ultimaker/Cura/wiki/Running-Cura-from-Source-on-Ubuntu,
i.e.
1. Clone the cura-build-environment repository.
2. Create a…
kiwih updated
4 years ago
-
Please have a setting equal to Cura (separate settings for Top and Bottom) for "Surface skin pattern and line directions"
"The pattern can be set separately to get a different visual effect. If set t…
-
### Application Version
4.5.0
### Platform
Windows 10
### Printer
Sovol SV01
### Reproduction steps
install cura
attempt to run cura
### Actual results
Splash screen appear…
-
I do not know if this is a plug-in issue or Cura project file issue:
Cura 5.4.0 (Linux Mint Cinnamon)
Calibration Shapes 2.2.4
I add two shapes (cylinders) to use as supports for my model
Repos…
TQM21 updated
8 months ago
-
We mainly do ceramic 3D printing, there is a problem with the bottom layer of printing, as shown below, please check the file.
Hi [smartavionics](https://github.com/smartavionics),
The red line in…
Eazao updated
7 months ago
-
Hi,
I am using lib3mf v2.0 to export a model and to later load it into Ultimaker/Cura.
Apparently, Ultimaker/Cura expects the metadata to look like this
```
... 0
```
meaning, it liter…
kcris updated
4 years ago
-
Adding tabs changes the dimensions of the model and scale % in the scale tool, even if only the model is selected. This is consistent across Cura 5.7.0 and another Cura-based slicer with an older Cura…
-
Repeated slicing failures on files I have successfully been using on other versions of Cura
-
Wondering how you were able to get such clean support removal for the indents in the top. In Cura using PETG on my Neptune 4 Plus, my "normal" supports are frozen in place and trees make for a sloppy …
k6lcm updated
2 months ago