-
### What radio module do you use?
E01-2G4M27SX (nRF24L01+), E01-ML01DP5 (nRF24L01+PA+LNA)
### What driver board(s) do you use?
ESP32-WROOM (ESP32 Dev Kit)
### If using Linux, what OS are y…
-
Hi there and thank you so much for taking the time to put this together. I have been studying hackintosh for a couple of weeks now preparing my first build.
I am set on itx form factor and was cons…
-
First write works fine and is received at the other end. But any write after that blocks forever in an infinite loop of "RF24 HARDWARE FAIL: Radio not responding, verify pin connections, wiring, etc."…
-
This may be intentional and I found a bug report on EnderIO page but dev said it wasn't his mod doing it so....
You can capture a cyberzombie in a soul vial but can't bind it to a broken spawner to…
-
```
What steps will reproduce the problem?
1. Calibrate all channels, turn the radio off.
2. Turn the radio on in less than 10 minutes after calibration- all is ok.
3. Turn the radio on after 30 minu…
-
```
What steps will reproduce the problem?
1. Calibrate all channels, turn the radio off.
2. Turn the radio on in less than 10 minutes after calibration- all is ok.
3. Turn the radio on after 30 minu…
-
```
What steps will reproduce the problem?
1. Connect to a wireless network (for myself it is wpa2 with an openwrt backend)
2. Keep phone in range of network and periodically wake up phone
3. Do this …
-
Hello @greearb
I am testing the commit 13319ff0b5dc3c86e8313f49fca583b829878736 for one week.
My router (Arcer C60 V2, QCA9886) became instable after install this commit.
On clients side, the co…
-
hi,
beautiful beautiful plugin, thank you very much
is there a way to integrate with knockout, because knockout reacts only to normal input changes
thanks in advanced.
-
```
What steps will reproduce the problem?
1. Connect to a wireless network (for myself it is wpa2 with an openwrt backend)
2. Keep phone in range of network and periodically wake up phone
3. Do this …