-
**Describe the bug**
The hotkey designated as "Print Plate" which is CTRL+SHIFT+G opens a dialog which appears to be a Bambu cloud print dialog. This does not provide an option to connect to the host…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
The printer trusts the last position it was even though the steppers were inactive. This can …
-
### Description of the bug
uploading perfectly fine 30 seconds prior then i suddenly get this.
Error uploading to print host:
HTTP 403: {"error": {"code": 403, "message": "Forbidden", "traceback": …
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
What this for hyroglyphs
### Bug Timeline
_No response_
### Expected behavior
_No response_
…
-
**Describe the bug**
I am using UBL 9x9 and when probing the bed with "G29 P1" it always fails on just 1 attempt. I have confirmed this on 3 different machines, an Ender-3v2 and 2 different Ender-3 S…
-
### Application Version
5.4
### Platform
win 10
### Printer
ender 3v2
### Reproduction steps
attempted to slice a file multplie times
### Actual results
keep getting error
### Expected resul…
-
Would be nice to be able to make the pause in-between the probing of 1 corner longer. It probes twice and then really only shows the results when it is ready to probe again which gives you a very smal…
-
When booting up Ender 3v2 with 8GB SD Card that came with the printer, intermittently may go into a boot loop where it will reboot a few times.
It doesn't seem to matter if the card has nothing on …
-
### Did you test with a precompiled firmware?
No, but I will test it now!
### Bug Description
Hi, My board is SKR MINI E3 V3 for Ender3-V2 and with Ender extender and with BTT Relay1.2
so, f…
-
I have 7 Ender 3 V2's, I was able to install this update on 5 of them but the newest ones won't load it. They all have 4.2.2 main boards. The only difference with the new ones is they have DACAI scree…